Hold requests long enough for me to restart upstream?

[Rt Ibmer]

Does anyone have some ideas about this? I have an update to do this weekend that will require me to bounce the upstream, and it would be great not to drop any connections in the process.  Hoping to hear something shortly.  Thank you!!

--- On Thu, 3/19/09, Rt Ibmer <rtibmx at yahoo.com> wrote:

> From: Rt Ibmer <rtibmx at yahoo.com>
> Subject: Hold requests long enough for me to restart upstream?
> To: "nginx" <nginx at sysoev.ru>
> Date: Thursday, March 19, 2009, 10:01 PM
> 
> I use nginx 0.6.31 with proxy_pass to front end requests to
> a servlet running in Jetty (the upstream).
> 
> Sometimes I need to update a jar on the upstream, which
> requires restarting jetty to take effect.
> 
> I am looking for a way to tell nginx that if it gets a
> connection failure at the upstream (which is what happens
> when jetty is in the process of restarting since nothing is
> listening on that port during the restart) that it should
> give it say 20 seconds before erroring out the request back
> to the browser.
> 
> Certainly this will back up the processing a bit, but it
> should be very short as it only takes Jetty about 10 seconds
> to restart and start listening again on its port. During
> slow periods we are only getting 2-5 requests per second so
> there should be plenty of resources for nginx to queue up
> these requests while it waits for Jetty.
> 
> Can someone please tell me what settings I should use so
> that nginx will wait up to 20 seconds for the upstream to
> restart so that it doesn't return an error to the browser?
> 
> In the past I have tried setting all these to 20 seconds:
>     proxy_connect_timeout   20s;
>     proxy_send_timeout      20s;
>     proxy_read_timeout      20s;
> 
> but when I restarted Jetty, right away the nginx error logs
> started showing errors like:
> [error] 6445#0: *141102686 connect() failed (111:
> Connection refused) while connecting to upstream
> 
> Are the above configuration parameters correct for what I
> am trying to do and maybe I just didn't set them right? Or
> is there some other way?
> 
> Basically what I'm trying to do is set those settings high,
> tell nginx to reload its config, then bounce jetty, then
> have nginx hold the requests long enough to get through once
> jetty is back up and then have the requests go through to
> jetty without losing any requests. Then after jetty is
> restarted I would put the timeouts back to normal levels
> like 3s, until the next time I have to do an update.
> 
> Either that or if I could send nginx a signal that told it
> to accept incoming connections but put them on "pause", then
> i can restart jetty and then unpause nginx once jetty is
> back up without dropping any connections.
> 
> Hopefully I explained this well what I am after. Please let
> me know your thoughts on the best way to do this.
> 
> Thank you!!
> 
> 
>       
> 
> 
>